Solution to failure of wire feeding frame of CNC wire forming machine

Numerical control wire forming machine is a kind of automation equipment commonly used in wire processing industry. The wire feeding frame is an important part of the wire forming machine, which is related to the automatic conveying and processing of the wire. So, how to solve the failure of the wire feeding frame of the CNC wire forming machine?
If the wire feeding frame of the CNC wire forming machine fails, it will affect the quality and efficiency of wire processing, and it needs to be resolved in time:

1. When the wire forming machine is started, the work light of the wire feeder does not display information, and there is no alarm, it is necessary to check whether the power switch of the wire feeder is closed, whether the power supply of the switch is powered, and the working voltage is It is not at the required operating voltage value, and whether the fuse tube is damaged;

2. After confirming that the wire feeding frame of the wire forming machine is powered on, but the wire feeding frame does not rotate, check whether the wire feeding frame motor can run, remove the transmission belt and test the motor, and check whether the soft starter has an alarm. If there is no alarm, the soft starter should be replaced immediately;

3. When the wire feeding frame of the CNC wire forming machine does not play the role of synchronous wire feeding, check whether the relay in the wire frame circuit board is burned out. If the working light of the relay is always on, it means that there is a problem and the problem needs to be replaced;

4. When turning the switch of the wire forming machine, check that the words "common faults of the wire rack" do not appear on the information frequency. If there is any need to check whether the support rods in the toggle switch box are in contact with the induction switches on both sides If not, adjust to touch or replace the sensor switch. WF-30 0.5-3.0mm 3-4 axis CNC cam wire forming machine is your good choice.