The working principle of the wire forming machine

The reel shaft of the wire forming machine is a through shaft, a bearing and a bearing seat are installed on the right side of the through shaft, the bearing seat is fixed on the support, and the support is fixed on the base; A driven pulley is installed on the left side of the bearing seat, the pulley is fixed on the sleeve of the through shaft, the inner side of the sleeve is fixed on the through shaft through the bearing, an automobile friction plate is fixed on the sleeve, and another friction plate(wire forming machine) on the left side of the sleeve is fixed on the through shaft; The left side of the automobile friction plate device is equipped with a bearing seat, the bearing seat is fixed on the support, and the support is fixed on the base; A wire reel is fixed on the left through shaft of the bearing seat; The right side plate of the reel is fixed on the through shaft, the right side plate is circular, the periphery is provided with a through hole, the reel pull rod is inserted into the through hole, the reel pull rod passes through the through hole of the right side plate and is movably connected through a pin shaft, the left side of the reel pull rod is provided with a reel left frame support rod corresponding to the reel pull rod, and the reel pull rod is hinged with the reel left frame support rod, The lower end of the reel frame support rod is hinged and fixed on the outside of the adjusting nut, the inner thread of the adjusting nut is screwed into the lead screw, the outer end of the lead screw is provided with an adjusting square head, the lead screw is inserted into the lead screw sleeve, the other end of the lead screw sleeve is fixed on the through shaft, the end of the lead screw insertion end is provided with a sliding groove, and the through hole of the lead screw sleeve wall is inserted into the pin and fixed in the sliding groove of the lead screw